Blind Nailing Siding

Face nailing figure 11 instead of blind nailing is recommended where the basic design wind speed is 100 miles per hour or greater.

Blind nailing siding.

For blind nailing hardieplank lap siding james hardie recommends driving. From the top edge and no closer than 3 8 in. Fasteners shall be installed between 1 in. Fasteners will be exposed on siding located immediately below window sills fascia boards and horizontal trim.

I wouldn t recommend blind nailing 1 2 in. Be sure to drive nails at least 3 8 from butt ends or use manufacturer specified joiners. With tongue and groove paneling the nails are inserted into the groove and hammered to below the surface. You are much better off face nailing with stainless steel 5d or 6d ring shank siding nails.

Blind nailing is a technique used to give a clean finished look to woodwork. Blind nailing preferred installation james hardie prefers and recommends installation of hardieplank lap siding by the blind nailing technique such that fasteners are hidden by the course above. Blind nailing refers to nailing each board one at a time and then overlapping that nailed layer with the next board so that all nails are hidden. Fasteners below window sill.

It s a safe and more effective way to install siding. Siding shall be installed with top blind nailing with the nails placed 3 8 inch 10 mm from either end and a minimum of 3 4 inch 19 mm from the top edge of the board. It also prevents problems with cracking and warping. Beveled clapboard siding unless you were going to expose only 3 in.

If you want to learn more about siding repairs and replacement findlay roofing can help. Keep blind nails between and 1 from the top edge of the panel figure 10. To ensure that the nail gets into the groove where it will be hidden it must be inserted at an angle.